Honda Civic: Automatic Lighting Control - Operating the Switches Around the Steering Wheel - Controls - Honda Civic Owners ManualHonda Civic: Automatic Lighting Control

Automatic lighting control can be used when

Automatic lighting control can be used when the ignition switch is in ON When you turn the light switch to ,.

When you turn the light switch to the, the headlights and other exterior lights will switch on and off automatically depending on the ambient brightness.

We recommend that you turn on the lights manually when driving at night, in a dense fog, or in dark areas such as long tunnels or parking facilities.

The light sensor is in the location shown below.

Do not cover this light sensor with anything; otherwise, the automatic lighting system may not work properly.

You can change the AUTO light sensitivity and

You can change the AUTO light sensitivity and automatic lighting off timer setting using the multiinformation display.

    Light Switches
    ■Manual Operation Rotating the light switch turns the lights on and off, regardless of the position of the ignition switch. ■ High beams Push the lever forward until you hear a cl ...

    Automatic Lighting Off Feature
    The headlights, all other exterior lights, and the instrument panel lights turn off within 15 seconds after you remove the key and close the driver's door. If you turn the ignition switch to LOCK ...

    See also:

    Parking in cold weather
    Do not use the parking brake when parking for long periods in cold weather since it could freeze in that position. Instead, you should observe the following tips. 1. Place the shift lever in “1” ...

    Power door locking switches
    Type A Type B 1) Lock 2) Unlock All doors and the rear gate (for 5-door) can be locked and unlocked by the power door locking switches located at the driver’s side and the front passenger’s si ...

    Rear brake caliper - removal, overhaul and refitting
    Caution: Ensure the ignition is switched off before disconnecting any braking system hydraulic union and do not switch it back on until after the hydraulic system has been bled. Failure to do ...