Mercedes-Benz C-Class: Belt warning for the driver and front passenger - Seat belts - Occupant safety - Safety - Mercedes-Benz C-Class Owners ManualMercedes-Benz C-Class: Belt warning for the driver and front passenger

Regardless of whether the driver and front passenger have fastened their seat belts already, the lights up for 6 seconds after every engine seat belt warning lamp lights up for 6 seconds after every engine start. It then goes out if the driver and the front passenger have fastened their seat belts.

If the driver's seat belt is not fastened after the engine is started, an additional warning tone will sound. The warning tone goes out after approximately six seconds or once the driver's seat belt is fastened.

If the driver or front passenger have not fastened their seat belt after 6 seconds and the doors are closed, the warning lamp lights up. seat belt warning lamp lights up.

• until the driver or the front passenger have fastened their seat belts
• if a vehicle speed of 15 mph (25 km/h) is exceeded once, a warning tone with increasing intensity sounds additionally for a maximum of 60 seconds or until the driver or front passenger have fastened their seat belts.

If the driver or front passenger undo their seat belts during the journey, the belt seat belt warning lamp lights up and the warning tone sounds again.

The warning tone ceases even if the driver or front passenger have still not fastened their seat belt after 60 seconds. The seat belt seat belt warning lamp stops flashing but continues to be lit.

Once the vehicle is stationary, the warning tone is reactivated and the belt seat belt warning lamp starts to flash again if the vehicle speed exceeds 15 mph (25 km/h) once.

The goes out if: seat belt warning lamp only goes out if:
• both the driver and the front passenger have fastened their seat belts.
or
• the vehicle is stationary and a door is open.

seat For more information on the belt warning lamp, see "Warning and seat belt warning lamp, see "Warning and indicator lamps in the instrument cluster, seat belt"

    Releasing seat belts
    Press release button 4 and guide belt tongue 2 back towards belt sash guide 1. Make sure that the seat belt is fully rolled up. Otherwise, the seat belt or belt tongue will be trapped in ...

    Emergency Tensioning Devices, belt force limiters
    The front seat belts and the outer seat belts in the rear are equipped with ETDs and seat belt force limiters. The ETDs tighten the seat belts in an accident, pulling them close against the bod ...

    See also:

    Audible reminder and warning when the engine stops
    When the P position selecting warning light ( ) in the instrument panel blinks in red. ● Make sure the shift selector is in the P (Park) position. When the chime sounds intermittently. ...

    Canceling the function for meter/gauge needle movement upon turning on the ignition switch
    It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position. Turn the ignition switch t ...

    List names function
    The voice tags registered in the phonebook are spoken by using the list names function. To use the list names function, perform the following procedure. 1. Select the “PHONE BOOK” menu. 2. Selec ...