Honda Civic: Low Beam Headlights - Replacing Light Bulbs - Maintenance - Honda Civic Owners ManualHonda Civic: Low Beam Headlights

Driver side

Driver side
1.8 ℓ engine models

1. Remove the holding clips (A). Push up the tab, and remove the cover of the air intake duct and its upper part.

2.4 ℓ engine models

2.4 ℓ engine models

1. Unlock the holding clips (B), then remove the cover of the air intake duct.

Fold in the upper part of the air intake duct

Fold in the upper part of the air intake duct to get enough working space.

Holding clip (A-type)

Pull the clip straight up to remove it.

Pull the clip straight up to remove it.

Keep the head of the clip raised when you insert it,

Keep the head of the clip raised when you insert it, push until it clicks.

Passenger side

All models

2. Remove the holding clip (C) using a flat-tip

2. Remove the holding clip (C) using a flat-tip screwdriver, then remove the upper part of the windshield washer reservoir.

Holding clip (B-type)

Press down the central pin until it clicks to unlock it.

Press down the central pin until it clicks to unlock it.

Push the central pin back to lock the clip. Then, insert

Push the central pin back to lock the clip. Then, insert the clip into the hole and press on the central pin until it is flat.

All models

All models

3. Remove the coupler.

It can be removed by pushing the tab.

4. Rotate the old bulb to the left to remove.

5. Insert a new bulb into the headlight assembly and turn it to the right.

6. Insert the coupler into the connector of the bulb.

Holding clip (C-type)

Insert a flat-tip screwdriver, lift and remove the

Insert a flat-tip screwdriver, lift and remove the central pin to remove the clip.

Insert the clip with the central pin raised, and push

Insert the clip with the central pin raised, and push until it is flat.

    High Beam Headlight
    1. Remove the coupler. It can be removed by pushing the tab. 2. Rotate the old bulb to the left to remove. 3. Insert a new bulb into the headlight assembly and turn it to the right. 4. Insert ...

    Fog Light Bulbs
    When replacing, use the following bulbs. Fog Light: 55 W (H11) 1. Remove the screw using a Phillips-head screwdriver and carefully pull the fog light assembly out of the bumper. 2. Remove t ...

    See also:

    Selection of manual mode
    NOTE Please read the following points carefully and bear them in mind when using the manual mode. • If you attempt to shift down when the engine speed is too high, i.e., when a downshift would pus ...

    Uniform Tire Quality Grading (UTQG)
    For details, refer to “Uniform tire quality grading standards”. ...

    Washer
    Washer To wash the windshield, push the washer button at the end of the wiper control lever. The washer fluid sprays until you release the washer button. The wipers operate while you push the button ...