Nissan Altima: NISSAN Intelligent Key™ battery discharge - Push-button ignition switch positions - Starting and driving - Nissan Altima Owners ManualNissan Altima: NISSAN Intelligent Key™ battery discharge

If the battery of the Intelligent Key is almost discharged,

If the battery of the Intelligent Key is almost discharged, the guide light A of the Intelligent Key port blinks and the indicator appears on the vehicle information display. See “Vehicle information display” in the “Instruments and controls” section.

In this case, inserting the Intelligent Key into the port B allows you to start the engine. Make sure the Intelligent Key is placed in the correct direction: The front side faces upward and the key ring side faces downward as illustrated.

To remove the Intelligent Key from the port, push

To remove the Intelligent Key from the port, push the ignition switch to the LOCK position and pull the Intelligent Key out of the port C .

NOTE:

The Intelligent Key port does not charge the Intelligent Key battery. If you see the low battery indicator, replace the battery as soon as possible. See “Battery replacement” in the “Maintenance and do-ityourself” section.

CAUTION

● Never place anything except the Intelligent Key in the Intelligent Key port. Doing so may cause damage to the equipment.
● Make sure the Intelligent Key is in the correct direction when inserting it to the Intelligent Key port. The engine may not start if it is in the wrong direction..
● Remove the Intelligent Key from the Intelligent Key port after the ignition switch is pushed to the LOCK position.

    Emergency engine shut off
    To shut off the engine in an emergency situation while driving perform the following procedure: – Rapidly push the push-button ignition switch 3 consecutive times, or – Push and hold the push- ...

    NISSAN vehicle immobilizer system
    The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key. If the engine fails to start using a registered key (for example, when interference ...

    See also:

    Safety Belt Extender
    If the vehicle's safety belt will fasten around you, you should use it. But if a safety belt is not long enough, your dealer/ retailer will order you an extender. When you go in to order it, take ...

    Windshield wiper blade rubber (type A and type B)
    NOTE The following illustrations show the replacement procedures of the blade rubber for a type A wiper blade assembly, however the replacement procedures are the same for a type B wiper blade assemb ...

    Supplemental air bag warning light
    The supplemental air bag warning light, displaying in the instrument panel, monitors the circuits for the air bag systems, pretensioners and all related wiring. When the ignition switch is ...