Honda Civic: Radiator - Maintenance Under the Hood - Maintenance - Honda Civic Owners ManualHonda Civic: Radiator

1. Make sure the engine and radiator are

1. Make sure the engine and radiator are cool.

2. Turn the radiator cap counterclockwise and relieve any pressure in the coolant system.

Do not push the cap down when turning.

3. Push down and turn the radiator cap counterclockwise to remove it.

4. The coolant level should be up to the base of the filler neck. Add coolant if it is low.

5. Put the radiator cap back on, and tighten it fully.

6. Pour coolant into the reserve tank until it reaches the MAX mark. Put the cap back on the reserve tank.

Removing the radiator cap while the

Removing the radiator cap while the engine is hot can cause the coolant to spray out, seriously scalding you.

Always let the engine and radiator cool down before removing the radiator cap.

NOTICE
Pour the fluid slowly and carefully so you do not spill any. Clean up any spills immediately; they can damage components in the engine compartment.

    Reserve Tank
    1. Check the amount of coolant in the reserve tank. 2. If the coolant level is below the MIN mark, add the specified coolant until it reaches the MAX mark. 3. Inspect the cooling system fo ...

    Automatic Transmission Fluid
    Specified fluid: Honda ATF DW-1 (automatic transmission fluid) Check the fluid level when the engine is at normal operating temperature. 1. Park on level ground, and start the engine. 2. Wait unt ...

    See also:

    LATCH Child-Restraint Systems
    Your Mazda is equipped with LATCH lower anchors for attachment of specially designed LATCH child-restraint systems in the rear seat. Both anchors must be used, otherwise the seat will bounce aroun ...

    Service and Warranty Information Booklet for US models and Warranty and Service Guide Booklet for Canadian models
    Please consult your Service and Warranty Information Booklet for US models and Warranty and Service Guide Booklet for Canadian models for additional information on service requirements. Mainten ...

    Checking the wiper blades
    Checking the wiper blades Run the tip of your fingers over the edge of the blade to check for roughness. Clean the wiper blade lips with water applied with a soft sponge. ...